About the XPENG G9 EV Charge Port Cover
The XPENG G9 EV charge port cover protects the exposed charging area during outdoor charging. It fits around the charging-port opening while a cable is connected, helping limit rain, snow, slush and road dirt reaching the socket area.
A locking knob secures the cover against the port opening. A removable lower flap lets you adapt the cable opening from Type 2 charging to CCS fast charging, so the same cover can be used with either connector configuration.
- Designed for the XPENG G9 charging-port layout
- Locking knob with locked and unlocked positions
- Adaptable opening for Type 2 and CCS charging
Installation:
- Open the charging-port flap and insert the cover into the opening at a slight angle. The tabs on the left edge should sit underneath and inside the seal around the opening.
- Lower the cover fully into the opening and press it evenly against the base of the charging port.
- Turn the knob to the locked position.
- For CCS fast charging, remove the cap from the CCS connector before installing the cover, then route its tether through the slot in the lower part of the cover.
Removal:
- Stop charging and disconnect the cable.
- Turn the knob to the unlocked position and remove the cover.
Switching between Type 2 and CCS:
To make room for a CCS connector instead of a Type 2 connector, remove the lower flap. From the back of the cover, spread the sides of the cable opening apart from the center while squeezing together the sides of the flap’s protruding tab. Once the tab releases from behind the retaining clips, push the flap upward toward the top of the cover.
Reassembly: Push the flap back into its groove until fully seated. Make sure the protruding tab locks behind the retaining clips on the back of the cover.